Agua Stop CEYS waterproofing sealant gray 1kg

DESCRIPTION
Agua Stop Waterproofing sealant is a preparation based on a concentrated dispersion of modified rubber with a special resin, glass fibers and reinforcing filler. After drying, it creates a film that adheres to the substrate, is waterproof and flexible enough with regard to the expansion of materials commonly used in construction.

PROPERTIES
Repairs and immediately eliminates water leaks in joints and cracks, crevices or holes. Seals the joints of gutters and drain pipes made of PVC. It repairs holes in patios and backyards, seals cracks in roofs and chimneys, and is resistant to tank water. Shut-off fitting.
Applicable under any climatic conditions, it adheres even under water to any surface: concrete, cement, PVC, metals, roof tiles and bricks.

APPLICATION
Urgent repairs even in the presence of water, snow, etc., applicable from -15 °C.
Sealing cracks in gutters and downspouts.
Sealing of drain pipes.
Tanks (with service water), sumps and inspection shafts.
Corners, masonry, large cracks and holes in covers.
Protection of water pipes and underground cellars.
Masonry and finishing between individual materials.
Plating.
Chimneys.
Gutters.
Sealing joints and cracks.
Repairs:
Roof bags
Gutters (metal and fiber cement) and drainage pipes made of PVC
Repair of cracks in roofing felt
Crack repair in boat hulls and RV bodies
It serves as a vapor barrier.

MATERIALS
Adheres (even without primer) to the following materials: concrete, cement mortar, fiber cement, metals, asphalt, PVC, butyl boards, wood, ceramic materials
NOT polystyrene
NOT natural stone

METHOD OF USE
To ensure maximum adhesion, the surfaces must be clean, dry and free of dust, grease, oils, remnants of previous coatings, salt efflorescence, fungi or any element or substance that is an obstacle to the adhesion of AGUA STOP waterproofing sealant to the substrate.
Cut off the end of the cartridge cap, screw on the cannula-spatula supplied with the product.
Apply the product using a spatula or a brick trowel or a classic silicone gun and spread it on the cartridge using a cannula-spatula. If you are repairing very damaged areas, we recommend repeating the application after 48 hours. On very wet substrates or substrates under water, test the application by pressing the spatula on the surface to be repaired. For applications under water, the adhesion of the product can be affected by the presence of algae on the repaired surface. For applications on sensitive materials, it is recommended to carry out the test in an inconspicuous place.